power commander

[Guest ady]

hi all, just bought a power commander(used) from ebay for my x11, although it was advertised for an x11 it is actually for a hornet (112 210) does any one know if it will still run properly on the x11

[x11r 386]

http://www.mpsracing.com/instructions/DynoJet/IE112-211.pdf

It looks like you have been sold one for a 2002/3 european model hornet , it is not the part number for an X11 , I would send it back unless you can get confirmation from dynojet that it will work.

Altho most dyno centers should be able to tell , it may just be the installed map that changes the part number however the conectors should be some indication.

Hope this helps